Troubleshooting - Black & Decker CS1020 Instruction Manual

NOTE: If you do not have a proper fitting
fence, use a straight edge guide in contact
with the edge of the shoe to improve
accuracy of cut and reduce the possibility
of binding and kickback.
Use only mild soap and damp cloth to
MAINTENANCE
clean the tool. Never let any liquid get
inside the tool; never immerse any part
of the tool into a liquid.
IMPORTANT: To assure product
SAFETY and RELIABILITY, repairs,
maintenance and adjustment (other than
those listed in this manual) should be
performed by authorized service centers
or other qualified service organizations,
always using identical replacement
parts.

TROUBLESHOOTING

• Unit will not start. • Cord not plugged in.
Problem Possible Cause
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
Black & Decker tools are properly
LUBRICATION
lubricated at the factory and are ready for
use.
ACCESSORIES Recommended accessories for use with
your tool are available from your local
retailer.
WARNING:The use of any accessory
not recommended for use with this tool
could be hazardous. Use only 7-1/4 "
(185mm) blades with 5/8" diameter
arbor. Exception: 7" (175 mm) abrasive
blades can be used.
When cutting metal, be careful of hot
sparks which are thrown by the blade.
Black & Decker offers a full network of
SERVICE INFORMATION
company-owned and authorized service
locations. All Black & Decker Service
Centers are staffed with trained
personnel to provide customers with
efficient and reliable power tool service.
Whether you need technical advice,
repair, or genuine factory replacement
parts, contact the Black & Decker
location nearest you.
• Plug tool into a working outlet.
Possible Solution
• Replace circuit fuse. (If the
product repeatedly causes the
circuit fuse to blow, discontinue
use immediately and have it
serviced at a Black & Decker
service center or authorized
servicer.)
• Reset circuit breaker. (If the
product repeatedly causes the
circuit breaker to trip,
discontinue use immediately
and have it serviced at a Black
& Decker service center or
authorized servicer.)
• Have cord or switch replaced
at Black & Decker Service
Center or Authorized Servicer
32
SPECIFCATIONS
CS1020 AR B2
Voltage: 220V 220V
Frequency: 50Hz 60Hz
Power: 1400W 1400W
RPM: 5000 5000
Printed in China
188115-00
4/19/07
33
B3 B2C BR
120V 220V 127V
60Hz 50Hz 60Hz
1400W 1400W 1400W
5000 5000 5000