Table of Contents
Advertisement
5019_715_02010_GB_IFU_SbS.qxp
Maintenance and cleaning
• Before any cleaning or maintenance operation, always unplug the appliance or disconnect it from the
power supply.
• Periodically clean the appliance with a cloth and a solution of lukewarm water and neutral detergent
specific for refrigerator interiors.
• Never use detergents or abrasives. Never clean the refrigerator parts with flammable liquids. The
fumes can cause fires or explosions.
• Clean the outside of the appliance and the door seals with a damp cloth and dry with a soft cloth.
• Do not use steam cleaners.
• Clean the condenser using a vacuum cleaner, proceeding as follows: remove the front kickplate (see
installation handbook) and carry out cleaning.
Important:
• The buttons and control panel display (located on the freezer door on some models) must be cleaned
with a dry cloth; do not use alcohol or alcohol-derived substances.
• The refrigerant system pipes are located near the defrost pan and can become very hot. Periodically
clean them with a vacuum cleaner.
Always disconnect the appliance from the power supply before replacing lamps.
Replacing the refrigerator compartment top lamp (in some models).
1. Undo the screw fixing the lamp cover.
2. Pull the cover downwards and slide it towards the inside of the refrigerator compartment.
3. Replace the lamp with one of the same type, available from the Customer Care Centre.
4. Refit the lamp cover by carrying out the above operation in reverse order.
Replacing the freezer compartment top lamp (in some models).
1. Remove the lamp cover by squeezing the sides.
2. Replace the lamp with one of the same type, available from the Customer Care Centre.
3. Refit the lamp cover by carrying out the above operation in reverse order.
Replacing the refrigerator and freezer compartment bottom lamp (in some models).
1. Remove the lamp cover by gripping it in the upper middle part.
2. Pull the lamp cover outwards, at the same time turning it slightly to one side.
3. Remove the blown lamp and replace it with one of the same type, available from the Customer Care
Centre.
4. Refit the lamp cover by carrying out the above operation in reverse order.
5. Insert the tabs on one side of the lamp cover in the corresponding grooves.
6. Carefully bend the lamp cover in the middle to insert the tabs on the other side.
Replacing the ice dispenser lamp (in some models).
1. Remove the lamp located in the ice dispenser recess.
2. Replace the lamp with one of the same type, available from the Customer Care Centre.
12-03-2007
9:36
Pagina 8
8
Advertisement
Table of Contents
