Submittals; Table 1. Nh Series Unit Options - Nortec NHPC Engineer's Manual

2. SUBMITTALS

A. INTRODUCTION
(1) The following pages are intended to be used by the engineer to determine the
component quantities required.
B. INSTALLATION COMPONENT SELECTION
(1) The following Tables 1 through 15 will enable the engineer to select components for
this installation.
Part No.
2522160 FILLCUP EXTENSION KIT NHTC/NHPC - 2 Required for 150 or 200
2522162 DRAIN WATER COOLER
005-020, to temper drain water below 120°F (49°C)
2522163 DRAIN WATER COOLER
030, to temper drain water below 120°F (49°C)
2522164 DRAIN WATER COOLER
050-075, to temper drain water below 120°F (49°C)
2522165 DRAIN WATER COOLER
100, to temper drain water below 120°F (49°C)
2522166 DRAIN WATER COOLER
150, to temper drain water below 120°F (49°C)
2522167 DRAIN WATER COOLER
200, to temper drain water below 120°F (49°C)
2522168 FOAM DETECTION NHTC HARDWARE
2522169 FOAM DETECTION NHPC HARDWARE
2522170 REMOTE FAULT INDICATION NHTC/NHPC
1469535 HIGH HUMIDITY ALARM PACKAGE
ON/OFF high limit duct stat w/indicator
1469536 LOW HUMIDITY ALARM PACKAGE
ON/OFF low limit duct stat w/indicator
1469537 HIGH HUMIDITY ALARM PACKAGE
ON/OFF high limit wall stat w/indicator
1469538 LOW HUMIDITY ALARM PACKAGE
ON/OFF low limit wall stat w/indicator
2522172 FACTORY PROVIDED EXTERNAL DRAIN AIR-GAP - REDUCER
146-9000 COUPLED CIRCUIT FOR DOUBLE UNIT
2522800 KEEPWARM, ALLOWING WATER TEMPERATURE IN THE CYLINDER TO
BE MAINTAINED AT 160°F (70°) FOR QUICK RESPONSE UPON A CALL
FOR HUMIDITY. NHTC OPTION ONLY.
2522803 UNIT NETWORKING NHTC AND NHTC OUTDOOR UP TO 1600 LBS/HR
ONE PACKAGE REQUIRED FOR EACH ADDITIONAL SLAVE HUMIDIFIER
DOUBLE UNIT 150/200 COUNTS AS 2 PACKAGES
10-30
Page 99
2008-10-01

Table 1. NH Series Unit Options

Description Qty