Steam Line And Condensate Return Line; Electrical; Primary Voltage Supply Wiring To Humidifier; Primary Voltage Supply Wiring From Humidifier(S) To Blower Packs - Nortec NHDI Installation & Operation Manual

Figure #11
Drain Line Connection
Supply Water
Connection
NHSC
3/8"
Scale
Collector
Tank
Drain
Water Cooler
Connection 3/8"
A
Drain
Connection B
1.5" O.D.
Model
010-090
135-180 Left
135-180 Right
Figure #12
Drain Connection
Clamp and 1.5" ID Hose
Factory Supplied
Air
Gap
Install a Copper Funnel for the NHSC model
and a Stainless Steel Funnel for the NHDI
model (by others).
Install a 2" O.D Copper Pipe for the NHSC
model and 2" O.D. Stainless Steel Pipe for
the NHDI model (by others).
NOTE: Steam hose should not
reach bottom of the funnel.
Figure #13
Drain Pump by others (if necessary)
Recommended Model
Gould - Model SSH
Consult Factory
Floor
Surface
Power
Inlet
Controls
Inlet
Optional
Cooling Kit
for SSR
(consult
factory)
7.95
(20.2)
23.0
(58.4)
A (in.) B (in.)
1.7" 5.4"
1.7"
5.4"
1.7"
20.3"
Humidifier
Drain Line
Line

STEAM LINE AND CONDENSATE RETURN LINE

1. Refer to the installation manual of the steam
distribution system used in your application.
Steam Distributor Form #XX-231, SAM-e
Form #XX-249, and Blower Pack Form
#XX-277.
PRIMARY VOLTAGE SUPPLY WIRING TO
HUMIDIFIER
1. Check and ensure that available voltage and
phase corresponds with operating voltage and
phase of humidifier as indicated on the
humidifier spec label, see Figure #1.
2. Ensure that an adequate power supply is
available to carry full humidifier amperage
drawn as specified by rated amps on the
humidifier spec label, reference to local codes.
3. A dedicated external disconnect must be
installed. Do not exceed the maximum circuit
protection amps as indicated on the
nameplate label.
4. Connect ground wire to cabinet ground clamp.
Do not use neutral wire of four wire supply as
ground.
5. Single phase humidifiers may be run on three
phase power, but load may unbalance power
grid.
6. External wiring sizes must be in accordance
with NEC and/or CEC and existing local
electrical codes and by-laws.
PRIMARY VOLTAGE SUPPLY WIRING FROM
HUMIDIFIER(S) TO BLOWER PACKS
1. All blower packs are wired (by others) to be
powered from the humidifier.
2. As a safety feature, blower packs come
equipped with a manual reset safety
thermostat and relay built into the blower pack
cabinet. The manual reset thermostat turns
off the humidifier if the blower pack gets
overheated. The control thermostat, mounted
on the steam distributor, starts the fan when
steam is generated.
3. All blower packs have high efficiency blowers
to minimize the frontal and overhead
clearance required to absorb the steam.
- 7 -

ELECTRICAL