Hardware Installation - D-Link DSA-3600 Quick Install Manual

1.4 Hardware Installation

Please follow the steps mentioned below to setup the hardware of DSA-3600.
1. Connect the power adapter to the power socket on the rear panel. The Power LED on the front panel
should be ON to indicate a proper connection.
Warning: Using a non-certified power adapter may damage this product.
2. Connect an Ethernet cable to the WAN1 Port on the rear panel. Connect the other end of the Ethernet
cable to a networking device such as an ADSL modem, a cable modem, a switch, or a hub. The LED of
WAN1 port should light up to indicate a proper connection.
3. Connect an Ethernet cable to any LAN Port on the rear panel. Connect the other end of the cable to a
networking device such as the administrator's PC. The LED of the LAN port should be ON to indicate a
proper connection.
DSA-3600 Quick Install Guide
4