Waeco CoolAir RT 880 Operating Manual page 33

RT880/SP950
7.2 Switching on the stationary air conditioner
NOTICE!
A
Never close all of the air nozzles of the stationary air conditioner
simultaneously. The device would ice up inside.
NOTE
I
The first time the stationary air conditioner is used, there may be a
slight smell. This is normal and soon goes away.
➤ With the system switched off, press the ON/OFF button (fig. 2 1,
page 3).
NOTE
I
If you completely switch off the stationary air conditioner, it can only
be switched on again using the control panel. The system can only
be switched on using the remote control if it is in standby mode. If
the system is not going to be used for a lengthy period, switch it off
completely so that the battery is not wasted supplying standby pow-
er.
✓ The fan starts at low speed.
✓ The Power LED (fig. 2 8, page 3) lights up.
✓ The digital display (fig. 2 5, page 3) shows the target temperature in °C
and the operating mode (e.g.
20 °C).
NOTE
I
The compressor is switched on after a delay of approx.
90 seconds.
EN
Using the stationary air conditioner
A20
for automatic mode + temperature
33