Connect To The Gas Supply; Leak Testing - Fisher & Paykel CG365DW Installation Instructions Manual

This appliance is factory set for use with Natural Gas at 4" W.C.P. or LP
Gas at 11" W.C.P. Check the label on the underside of the appliance.
Gas regulator
For use with a gas pressure regulator as shown.
●
For LP models the regulator cap should be marked 'LP'.
Leak testing of the appliance shall be conducted according to the manufacturer's
●
The appliance and its individual shut-off valve must be disconnected from the gas supply piping system during
●
any pressure testing of that system in excess of 1/2 psi (3.5kPa).
The appliance must be isolated from the gas supply piping system by closing its individual manual shut-off valve
●
during any pressure testing of the gas supply piping system at test pressures at or less than 1/2 psi (3.5 kPa).
Maximum inlet gas supply pressure 20" W.C. (5 kPa)
●
Minimum gas supply pressure for regulator testing 5" W.C. Natural Gas, 12" W.C. LP Gas.
●
After installing the gas supply and making all connections, check thoroughly for possible leaks:
1 Turn all control dials on unit to "OFF" position.
2 Open the valve on the gas supply.
3 Using a leak detection fluid (eg Rocol leak detection spray), check each gas connection one at a time by spraying
or brushing the solution over the connection. The presence of bubbles will indicate a leak.
4 If necessary, tighten the fitting and recheck for leaks.
5 Turn on burner valve and light each burner.
6 Check for a clear blue flame without yellow tipping. If burners show any abnormalities, check that they are
located properly and in line with the injector orifice.
9
!1

CONNECT TO THE GAS SUPPLY

Pressure
Regulator
shows
Direction of
Gas Flow
!2

LEAK TESTING

instructions.
Cooktop
To Cooktop
Regulator
Solid or Flexible
Connector
Shut-Off
Valve
Pipe Stub from
House supply
ON
ON
GAS
GAS