Installation; Gas Supply Connection; Gas Regulator - Fisher & Paykel GC36 Installation Instructions Manual

Installation Instructions
Gas supply connection
This appliance is factory set for use with
Natural Gas at 4"of water column pressure.
It carl also be used ors LP Gas at 11"of water
column pressure after conversion (see pages
7&8).
A manual shut-off valve must be installed
in an accessible location in the gas line
external to the appliance for the purpose
of turning ors or shutting off gas to the
appliance. (In Massachusetts such shutoff
devices should be approved by the Board of
State Examiners of Plumbers & Gas Fitters).
Gas corsrsectiorsto the product must use
the elbow supplied with a 72" NPT external
thread.
Ensure the blue washer (supplied) is
located between the elbow and the
product inlet. Failure to use this will
cause a gas leak.
Blue Elbow
(Note: this didgrdm is of GC36but issimildr for GCR 12ond
GC912M).
Gas Regulator
For use with a gas pressure regulator as
shown below. The regulator supplied can
be set for either LP gas or Natural gas.
n , •
J
Pressure ,4D-& .......... /
shows _ U_ .... / %.
Direction of _ _ _ ......................
Gas Flow ouse supply