Related Manuals for Aerial AD 810
Summary of Contents for Aerial AD 810
- Page 1 Instruction manual _____________________________________ Dehumidifier AD 810 _____________________________________ valid: 10-2010 page 1 of 14...
-
Page 2: Table Of Contents
Index Illustration 1.1. View from the rear AD 810 General advice Mode of functioning Safety Installation and transport Operation 6.1. Electrical connection 6.2. Putting into operation 6.3. Operation panel 6.4. Hygrostat control 7 - 8 6.5. Condensate removal 8 - 9 6.6. -
Page 3: Illustration
4 pcs. Cators, fixable (D= 100 2.General advice You have bought an air dryer made by AERIAL thus deciding for a proven quality product "Made in Germany". If there are any questions, you will find some advice in this manual how to eliminate such difficulties as quickly as possible. -
Page 4: Mode Of Functioning
Please, keep the device wrapping in order to be able to send the device safe for guarantee repair. In order to save space you open simply the adhesive tape with a knife and you fold the carton. 3.Mode of functioning The AD-air dryer is built particularly for air drying in closed rooms. -
Page 5: Safety
The operator must make the operating instruction available for the user and make sure that the user did understand the manual. 5. Installation and transport The dehumidifiers of series AD 810 are conceived for the mobile or stationary employment. During the setting up and transportation of the dehumidifier, the following items are to be considered: Ø... -
Page 6: Operation
6. Operation 6.1 electrical connection Before connecting the air dryer, the following items must be checked: Ø Does the mains voltage coincide with the voltage of the appliance? Ø Adequate fusing of socket and supply system? Ø Has a residual-current-operated circuitbreaker (r.c.c.b) been installed? Ø... -
Page 7: Operation Panel
6.3 Operation panel On-/Off-switch Hygrostat (Pkt. 6.4) neon: Check pump (Pt. 6.5) Ventilation slot for room air flow Operation time for hygrostat (do counter not cover!!!) 6.4 Hygrostat control The air dryers of the AD-series dispose of a hygrostat for setting the required humidity value. -
Page 8: Condensate Removal
Ask your technical consultant in the case of special applications. 6.5 Condensate removal The dehumidifier AD 810 is serially equipped with a built in condensate pump. The condensate pump is placed below the air filter, behind the back plate. In the back plate a connector and a button is placed. Afitting connection piece is included with the delivery. -
Page 9: Automatic Defrosting
During air drying, ice may form at the evaporator. The volume of ice depends on the ambient conditions prevailing in the room to be dried. The AD 810 is equipped with an automatic hot-gas defrosting. It ensures that, depending on the extent of ice formation, the appliance will be defrosted automatically according to the following principle: Ø... -
Page 10: Technical Data
In the case of doubtful operating conditions it is recommended to contact the Technical Department of Messrs. AERIAL or a specialized dealer. Using an AD-air dryer under inadequate operating conditions will entail that the warranty becomes null and void. -
Page 11: Service And Maintenance
Ø mount cover (front/top-panel). Ø Clean case with moist cloth. Do not use aggressive detergent Ø Insert new or cleaned filter. Use only original AERIAL-filter for problemfree working. Ø Insert filter holder Ø Put plug into socket Ø... -
Page 12: Trouble Shooting
10. Trouble shooting Assign that dehumidifier a putative defect on, please, first check the following points. If this should provide no relief, please contact your technical consultant. 1) The dehumidifier shows a bad or no drying capacity - The humidity is lower than 40% r.h. or the temperature in that room is lower than +3°C. -
Page 13: Disposal
If you have any questions regarding defects and malfunctions of AERIAL-air dryers we recommend get in touch with your supplier. The producer AERIAL GmbH you reach under 0049-40-526879-0 or www.aerial.de 11. -
Page 14: Manufacturer´s Declaration
12. Manufacturer´s declaration (EU-directive 98/37/EG) (EU-directive 2004/108/EG) (EU-directive 73/23/EWG) manufacturer: AERIAL GmbH - Systeme zur Luftbehandlung Oststraße 128, D-22844 Norderstedt Product description: dehumidifier type AD 810 capacity: 105,0 l/day The product described above is an ambient air dryer ready for connection.
Need help?
Do you have a question about the AD 810 and is the answer not in the manual?
Questions and answers