ESAB CUTMASTER A60 Operating Manual page 88

CUTMASTER A60
WARNING
!
Always turn OFF the air supply and
bleed the system before disassembling
the Filter Assembly as injury could
result.
3. Loosen the two bolts on the top of the Filter As-
sembly enough to allow the Filter Elements to
move freely.
4. Note the location and orientation of the old Filter
Elements.
5. Slide out the old Filter Elements.
Optional Two-Stage Filter Replacement
6. Slide the replacement Filter Elements into the
Filter Assembly, with the same orientation as
noted in Step 4 above.
7. Hand tighten the two bolts evenly, then torque
each bolt to 20 - 30 in-lbs (2.3 - 3.4 Nm). Im-
proper torque may damage the gasket.
8. Slowly apply air pressure to the assembly, check-
ing for leaks.
NOTE!
A small amount of air leakage from the
bottom fitting is normal.
This completes the parts replacement procedures.
5-8
First & Second
Stage
Cartridges
(as marked)
Art # A-02942
SERVICE 0-5428