Table of Contents
Advertisement
1
A
MIN
MAX
PSI
MAX
!
STANDOFF
Cutmaster A60 Gas Pressure Settings
SL60
Leads Length
(Hand Torch)
Up to 25'
75 psi
(7.6 m)
5.2 bar
Each additional
Add 5 psi
25' (7.6 m)
0.4 bar
3. For Drag cutting, adjust gas pressure from 75 -
95 psi / 5.2 - 6.5 bar (LED's in center of control
panel). Refer to the Drag Cutting chart for pres-
sure setting details.
DRAG
Cutmaster A60 Gas Pressure Settings
Leads Length
Up to 25'
(7.6 m)
Each additional 25'
(7.6 m)
Select Current Output Level
1. Place the Function Control Knob in one of the
three operating positions available:
RUN
,
RAPID AUTO RESTART
or LATCH
0-5428
2
BAR
MAX
+
MIN
MIN
Art# A-07946
SL100
(Mechanized Torch)
SL 100 SV
(Automation Torch)
75 psi
5.2 bar
Add 5 psi
0.4 bar
SL60
(Hand Torch)
80 psi
5.5 bar
Add 5 psi
0.4 bar
. Gas flow stops.
2. Set the output current to desired amperage with
the Output Current Control Knob.
Cutting Operation
When the torch leaves the workpiece during cutting
operations with the Function Control Knob in the
RUN position, there is a brief delay in restarting
the pilot arc. With the knob in the RAPID AUTO
RESTART position, when the torch leaves the work-
piece the pilot arc restarts instantly, and the cutting
arc restarts instantly when the pilot arc contacts the
workpiece. (Use the 'Rapid Auto Restart' position
when cutting expanded metal or gratings, or in goug-
ing or trimming operations when an uninterrupted
restart is desired). And with the knob in the LATCH
position the main cutting arc will be maintained after
the torch switch is released.
Typical Cutting Speeds
Cutting speeds vary according to torch output am-
perage, the type of material being cut, and operator
skill. Refer to Sections "4T.08
Cutting Speeds for Machine and Automated Torches
With Exposed Tip" and following for greater details.
Output current setting or cutting speeds may be
reduced to allow slower cutting when following a
line, or using a template or cutting guide while still
producing cuts of excellent quality.
Postflow
Release the trigger to stop the cutting arc. Gas con-
tinues to flow for approximately 20 seconds. During
post - flow, if the user moves the trigger release to
the rear and presses the trigger, the pilot arc starts.
The main arc transfers to the workpiece if the torch
tip is within transfer distance to the workpiece.
Shutdown
Turn the ON / OFF
All Power Supply indicators shut OFF. Unplug the
input power cord or disconnect input power. Power
is removed from the system.
OPERATION
CUTMASTER A60
Recommended
switch to OFF
(down).
4-3
Advertisement
Table of Contents
