I/O Control Instruction; Hardware Installation; Physical Installation - Planet RS-21 KLMR User Manual

6. Line out (audio out)
Connect a loud speaker to the network camera. This is for voice alert and two-way audio.

2.1.2 I/O Control Instruction

1) Please connect the GND and DO pin to the external relay (buzzer) device.
2) Please connect the GND and DI pin to the external trigger device.
3) I/O Pin definition
GND (Ground): Initial state is low
DO (Digital Output): 5V DC
DI (Digital Input): Max. 50mA, 5V DC

2.2 Hardware Installation

2.2.1 Physical Installation

1. Connecting an Ethernet cable
Connect the LAN cable on the camera to the network device (hub or switch).
If there is an IEEE802.3af PoE switch on your network, you can connect the
camera LAN cable to this PoE switch to obtain power. The power adapter is
unnecessary when Internet camera is connected to a PoE switch.
2. Attaching the power supply
Plug in power adapter and connect to power source. After power on, the camera will start
to operate.
1. Only use the power adapter supplied with Internet camera. Otherwise, the
product may be damaged.
2. The power adapter is unnecessary when Internet camera is connected to a PoE
switch. Otherwise, the product may be damaged when Internet camera is
connected to a PoE switch and power adapter simultaneously.
3. Attaching BNC connector
Connect the video BNC connector to a monitor set if necessary. Check camera viewing
Full HD Outdoor IR POE IP Camera
13
ICA-3250V