Table of Contents
Advertisement
Interval
Based on the
schedule
Tampering Detection
Record File Setting
Record Time Setting
Network Disconnected
Network IP check
"Area Setting" and use mouse to drag and draw the area. The
same operation is done for areas 2 and 3. If you select "save to
SD card", the video or snapshot will be saved to Micro SD
card. If you also tick E-mail/ FTP/ Samba of "Log" option, the
motion detection log will be sent to E-mail/ FTP/ Samba
simultaneously.
For example, if you select "10 sec" here, once the motion is
detected and action is triggered, it cannot be triggered again
within 10 seconds.
When the option box is ticked, only during the selected
schedule time the motion detection is enabled. That is, for
example, the 11th hour of Monday has not been colored in the
schedule table, then no action will be triggered even the
camera detects motion during 11:00~12:00 on Monday.
When the camera view is covered, moved, hit by strong light,
or out of focus, the tampering detection will be triggered, and
send snapshot or video to mail/FTP/Samba/SD card, or trigger
the external alarm.
IP camera allows 3 different types of recording file to change
its record size. When motion/alarm is triggered, there are 3
different types of recording modes:
(1) AVI File (With Record File Setting )
(2).Multi-JPEG (With Record File Setting), only with JPEG
compression format.
(3) Single JPEG (Single File with Interval Setting)
Pre Alarm and Post Alarm setups for video start and end time
when motion detects I/O, or other devices got triggered.
Pre/Post Alarm record time is based on record time
setting and IP cam built-in RAM memory. Limited
by IP cam built-in RAM memory, when information
is too much or video quality is set too high, it will
cause recording frame to drop or decrease on post
alarm recording time.
To avoid video loss, the camera will start to save the video
to local SD card when it detects no network connection. The
video recording will continuously be saved onto SD card and
divided into every 10 minutes a file until the network is
reconnected successfully. The oldest file will be deleted if the
capacity of SD card is full.
Key- in the target IP address and interval. The camera checks
once in a while according to the setting interval time if it can
link to the target IP address. If connection fails, the camera
starts to save the video to SD card
55
Full HD Outdoor IR POE IP Camera
ICA-3250V
Advertisement
Table of Contents
