Table of Contents
Advertisement
LIM Bypass
Control
panel rear
AUX Port
Control
Selector Switch
panel rear
(Optional)
The control panel includes the following connections:
Connection
Power (100-240 Volts AC,
50, 60 Hz)
GFCI/Circuit Breaker
Protected Power Outlets (2)
Tether Whip
(Specifications)
Monitor Power
Analog Video Out
USB PC
USB Accessories (3)
AUX Port (Specifications
listed below)
Ethernet (Optional)
BlueView Pole Mount
(Optional)
AUX Port Specifications
Connector Type - DB-9 Male.
Pin
1
No connection
2
No connection
3
No connection
4
No connection
5
No connection
6
No connection
7
AUX + (Connects to tether pin 4 and ROV accessory port pin 4)
If the LIM alarm state has been triggered, the LIM can be bypassed by enabling
this switch.
If the LIM bypass switch is enabled, LIM protection is disabled.
This situation can pose a risk to people handling the tether or in the water with
the ROV. Do not use the LIM bypass switch unless you have examined the
system to make sure it is safe, or are sure that people are not going to be
exposed to a possible voltage leak in the tether or ROV.
Switches the APIC circuit between the AUX Port and a dedicated accessory
interface, such as an Ethernet connector, if one is included.
Type
IEC male
Used to connect the control panel to a power source.
IEC
Used to connect the computer and another device to the control
female
panel to receive power.
8 pin
Used to connect the control panel to the tether for power,
round
communications, video and accessory support.
female
Provides 12 Volts DC. Used to provide power to the monitor.
RCA
Provides a composite video signal. Can be used to connect an
female
analog video recording device.
Type B
Used to connect the control panel to the computer.
female
Type A
Can be used to connect USB devices to the computer via the control
male
panel.
DB-9 male Provides access the APIC (Auxiliary Pair of Independent
Conductors) in the tether. Can be used with ROV accessories that
need to rely on the APIC for communications.
RJ-45
Can be used to connect the control panel to the computer for
female
Ethernet based ROV accessories.
Used to connect the BlueView Pole Mount system to the control
panel.
Function
38
Function
Advertisement
Table of Contents
