Table of Contents
Advertisement
Camera->SPECIAL Sub-menu: MOTION DET
MENU
DESCRIPTION
ITEM
MOTION
Set the Motion Detection feature On or Off. When motion is detected, the camera will flash a white
MODE
square in the area where the motion is detected. See the
how to display the motion indicator once it has been set to On.
ON - Set the Motion Detection feature On.
OFF - Set the Motion Detection feature Off.
ZONE
Set the Motion Detection Zone. The Motion Detection Zone is an area of the image where motion
is to be detected.
TOP - Set the Motion Detection Zone to the top 1/3 of the image.
BOTTOM - Set the Motion Detection Zone to the bottom 1/3 of the image.
CENTER - Set the Motion Detection Zone to the central area of the image.
LEFT - Set the Motion Detection Zone to the mid-left area of the image.
RIGHT - Set the Motion Detection Zone to the mid-right area of the image.
WHOLE - Set the Motion Detection Zone to the whole image.
LEVEL
Set the sensitivity of the Motion Detection. Lower numbers will be less sensitive to motion and it
will take more motion to trigger the detection.
0
1
2
3
4
5
INITIAL
Reset this sub-menu to the factory default state. VideoRay uses optimized camera menu settings
and the factory default settings should not be used. If you want to reset this sub-menu to the
VideoRay optimized settings, use the recommended settings described for this sub-menu.
RETURN
Return to the Special sub-menu.
Settings in bold are available for use with the VideoRay Pro 4. VideoRay defaults are underlined.
DISPLAY
120
sub-menu for information on
Advertisement
Table of Contents
