Table of Contents
Advertisement
VideoRay Ship Hull Inspection Stabilizer Operating Tips
The Hull Inspection Stabilizer is easy to mount and use.
Hardware Set Up
1.
Remove the float block retaining screw and washer. Save the screw and washer for reuse without the Hull
Inspection Stabilizer
2.
Install the Hull Inspection Stabilizer on top of the float block with the vertical thruster hole aligned. The
bottom of the stabilizer has a contoured cut out that matches the top of the float block shape.
3.
Install the longer float block retaining screw that came with the stabilizer.
Operation
When using the Hull Inspection Stabilizer, the Controller Sensitivity can be set to custom values to improve the
effectiveness and ease of use. The following settings are recommended for starting.
Surge (Forward and Reverse) 100
Yaw (Left and Right)
Up
Down
These settings can be saved using the Custom button on the Controller Sensitivity instrument. See the
Controller Sensitivity
section for more information about setting and saving custom controller settings.
This equipment is optional and may not be included in all VideoRay Pro 4 configurations.
100
100
70
225
Advertisement
Table of Contents
