Table of Contents
Advertisement
VideoRay Cutter Operating Tips
The Cutter is easy to mount and use.
Hardware Set Up
1.
Mount the inner clamp on the skid using the supplied screws.
2.
Place the cutter in the clamp and install the outer clamp using the supplied screws.
3.
Remove the 9 Pin Accessory Port Dummy Plug from the Accessory Port.
4.
Install the 9 Pin connector from the Cutter into the Accessory Port.
Operation
Use the buttons on the
hand controller
The
manipulator instrument
This equipment is optional and may not be included in all VideoRay Pro 4 configurations.
to open or close the cutter.
will indicate the status of the cutter activity.
223
Advertisement
Table of Contents
