Viking HB 445 Instruction Manual page 27

Starting:
Exercise care when starting and observe
the instructions contained in the section
entitled "Initial operation of machine".
( 11.)
Ensure that you keep your feet far enough
away from the work tools.
The machine must not be tilted during
start-up.
The self-propulsion levers must not be
pressed when starting.
Working on slopes:
Always work across and back on slopes,
never up and down.
The operator must never stand below the
running machine on a slope. If the user
loses control, there is a risk of being run
over by the machine.
Be particularly careful when changing
direction on a slope.
Always ensure good stability on slopes
and avoid mowing on excessively steep
slopes.
The machine can tip over when used on
slopes. For safety reasons, the machine
must not be used on slopes with an
inclination of more than 15° (26.8 %). Risk
of injury!
A slope inclination of 15° corresponds to a
vertical height increase of 26.8 cm for a
100 cm horizontal distance.
0478 403 9800 H - EN
In order to ensure an adequate oil supply
for the engine, the information in the
accompanying engine instruction manual
must be additionally observed when using
the machine on slopes.
Working:
Risk of injury
Never place your hands or feet
above, underneath or on rotating
parts.
For safety reasons, the machine must
always be operated using both hands,
which must be kept on the handles of the
handlebar at all times during operation.
Never work using only one hand.
Only control the working depth by applying
pressure to the brake spur.
Use the machine with particular care when
operating on difficult (e.g. stony and hard)
ground. Reduce the rotational speed of the
work tools (fuel control).
Only operate the machine at walking
speed – never run when working with the
machine. Working quickly with the
machine increases the risk of injury due to
stumbling, slipping, etc.
Caution – risk of injury!
Exercise particular caution and ensure that
there is sufficient distance between the
work tools (hoes) and your feet when
turning the machine around, pulling it
towards you, or using reverse gear.
Caution – Risk of stumbling!
Watch out for obstacles behind the
operator when moving the machine
backwards.
If the machine becomes stuck, stop the
engine and detach the spark plug socket.
Lift the machine with the help of a second
person and free it.
Stop the engine
– when the machine has to be tilted for
transportation
– when pushing or pulling the machine to
and from the area to be worked
– when leaving the machine unattended
– before re-filling the tank. Allow the
engine to cool down before re-filling the
tank. Fire hazard!
– when pushing or pulling the machine on
an area that is not to be worked.
Stop the engine and detach the spark plug
socket:
– before remedying blockages
– before lifting or carrying the machine
– before transporting the machine
– before checking or cleaning the
machine or before carrying out any
other work (e.g. adjusting the
handlebar, folding out the transport
chassis) on it
– after hitting a foreign object or if the
machine vibrates excessively. In these
cases, check the machine, in particular
the work tools (hoes, hoe retainers,
drive shaft), for damage and carry out
the necessary repairs before restarting
and working with the machine.
25