Table of Contents
Advertisement
Figure 1. Cable management bracket installation
1 Rear Cutout
2 Extender
3 Tailgate Insert
Cable Installation Procedure, Initial Setup
Note: Do not connect any switch cables to the nodes until instructed to do so.
1. Place the frame in position over the floor tile cutouts
v If the frame has 10 or more nodes installed, the movers will position the frame
2. Install the frame using the appropriate installation instructions
3. Verify that the cable management bracket is properly installed on the base at the rear of the frame, if
not:
a. Remove orange shipping bracket from the rear of the frame
b. Install the stiffener into the rear cutout on the base of the frame
162
Eserver pSeries 655 Installation Guide
4 Cable Management Backet
5 Stiffener
Advertisement
Table of Contents
