Troubleshooting - Nokia Mediamaster 221 T Owner's Manual

Troubleshooting

Problem
The LED on the front panel does
not light up/is not lit.
The left LED is shining red
The remote control is not working.
You have forgotten your Access
code.
During the first time installation
when the Mediamaster tries to find
and store channels you get the
message "No channels found".
When only very few of the ex-
pected number of channels are
found.
There is no First time installation
menu on the screen when you
switch on the Mediamaster for the
first time.
What to do if you can't solve the problem?
If you have tried all of the actions suggested above, without solving the problem, please contact your
Retailer or Nokia Support.
GB 28
Possible causes
Mains cable is not connected.
The Mediamaster is in standby
mode.
Battery exhausted.
Remote control is incorrectly
aimed.
The aerial is not properly connected
to the Mediamaster.
The aerial is not correctly directed
towards the transmitter.
The aerial is not suitable for digital
channels.
The signal is too weak for the con-
nected aerial.
There are no terrestrial digital trans-
missions in the area.
The system is connected by SCART
cables and the TV is not in AV/EXT
mode.
The system is connected by RF ca-
bles and the TV is not set to the
channel tuned for digital terrestrial
TV.
What to do
Check that the mains cable is
plugged into the power socket.
Press the standby button to bring the
Mediamaster out of standby mode.
Change both batteries.
Aim the remote control at box.
Check that nothing blocks the front
panel.
Contact your Nokia Support.
Check the aerial installation including
its connections.
Check if you can receive and watch
analogue channels from the transmit-
ter.
Check that the aerial is directed to-
wards the transmitter.
Check that digital transmissions are
available in the area.
If things do not work as they should,
let the local TV dealer check whether
the aerial is intended for receiving
digital transmissions or not. If not,
you have to upgrade the aerial.
When the system is connected by
SCART cables the TV must be set in
AV/EXT mode.
When the system is connected by RF
cables, select the appropriate TV
channel on the TV. If you have not yet
tuned the TV to the same output
channel as the Mediamaster, you
must do this before you get picture
and sound from it.