Troubleshooting - Nokia Mediamaster 150T User Manual

TROUBLESHOOTING

Problem
The LED on the front panel does not
light up/is not lit.
The left LED is red.
The remote control is not working.
You have forgotten your PIN code.
During the first time installation when
the Mediamaster tries to find and store
channels you get the message "No
channels found".
When only a few of the expected
number of channels are found.
There is no First time installation
menu on the screen when you switch
on the Mediamaster for the first time.
What to do if the problem cannot be solved?
If you have tried everything suggested above and the problem is still unsolved, please contact your dealer or Service Pro-
vider for assistance.
Possible causes
The mains cable is not connected.
The Mediamaster is in standby mode.
The battery is dead.
The remote control is being pointed properly.
The aerial is not propperly connected to the
Mediamaster.
The aerial is not correctly directed towards the
transmitter.
The aerial is not suitable for digital channels.
The signal is too weak for the connected
aerial.
There are no digital terrestrial transmissions in
the area.
The system is connected by SCART cables
and the TV is not in AV/EXT mode.
The system is connected by RF cables and the
TV is not set to the channel tuned for digital
terrestrial TV.
What to do
Check that the mains cable is plugged
into the power socket.
Press the standby button to bring the
Mediamaster out of standby mode.
Change both batteries.
Aim the remote control at the box.
Remove anything that might be blocking
the front panel.
Contact your Service Provider. They will
help you set it up again.
Check the aerial installation, including its
connections.
Check if you can receive and watch ana-
logue channels from the transmitter.
Check that the aerial is directed towards
the transmitter.
Check that digital transmissions are avail-
able in the area.
If no channels are found after trying the
other steps, let the local TV dealer check
whether the aerial is intended for receiv-
ing digital transmissions or not. If not, you
must exchange the aerial.
When the system is connected by SCART
cables, the TV must be set in AV/EXT
mode.
When the system is connected by RF ca-
bles, select the appropriate TV channel on
the TV. If you have not yet tuned the TV
to the same output channel as the
Mediamaster, you must do this before
you can get picture and sound from it.
GB 31