Table of Contents
Advertisement
Navi Bars
Settings folder
To open this menu you will be asked to enter your access code.
From the factory the access code is set to 1234.
From here you can adjust the audio/video settings for your Media-
master.
TV screen format
Select your TV screen format.
The 4:3 format is the standard format for most TV screens.
Select 16:9 for a widescreen TV.
Position of the RGB output
Adjust the horizontal position of the TV picture with the
tons.
Set transparency level
Adjust the transparency level of the graphics in the menus by
using the
buttons.
Select digital audio format
Select audio format for the digital output. (The upper audio
output on the rear of the Mediamaster). AC-3 when the sound is
transmitted in Dolby™ Digital format. PCM for ordinary digital
sound. Please note; When you select AC-3 there will be no
sound output from the analogue audio connections.
Picture format
If you have a TV set with the 4:3 picture format and the transmis-
sion is in 16:9, you can select "Fullscreen" or "Letterbox". If you
have the stretched and boxed format 14:9, you select "Com-
bined".
Fullscreen will fill up the screen but will cut off some information
on the left and right sides.
Letterbox will give a complete picture, but leave black areas at
the top and bottom.
Combined will give black areas both at the top and bottom and
also on both sides
RF modulator output channel
Select this alternative if you have to change the RF channel.
(Channel 43 is preset from factory.)
When you change the RF channel number, you must also change
to the same value on the TV. If you do not, there will be no pic-
ture and sound.
GB 20
☛
TV
but-
fullscreen
letterbox
Advertisement
Table of Contents
