Operation; Before Startup; Description Of The Appliance - Kärcher K 5.55 M Manual

Hide thumbs Also See for K 5.55 M:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 14

Operation

Description of the Appliance

When unpacking the product, make sure
that no accessories are missing and that
none of the package contents have been
damaged. If you detect any transport dam-
ages please contact your dealer.
Illustrations on fold-out pag-
es!
1 Coupling element for water connection
2 Waterfilter
3 Connection for water supply with filter
4 High pressure hose
5 Appliance switch "0/OFF"/ „I/ON"
6 High-pressure hose drum
7 Detergent Tank
8 Dosage regulator for detergent
9 T-Racer bracket
10 Rubber band
11 Storage for spray lance
12 Storage for trigger gun
13 Transport handle
14 Storage for mains connection cable
15 Screws
16 Mains cable with mains plug
17 Axle
18 Sleeve
19 Bearing wheel
20 Wheel cap
21 Expanding rivet
22 Supporting foot
23 Rotary washing brush
24 Spray lance with pressure regulation
(Vario Power)
25 Spray lance with dirt blaster
26 Lock trigger gun
27 Key to detach the high-pressure hose
from the trigger gun
28 Trigger gun
29 hand crank for hose drum
Special accessories
Special accessories expand the possibili-
ties of using your appliance. Please contact
your Kärcher dealer for further information.

Before Startup

Mount loose parts delivered with appliance
prior to start-up.
Illustrations on fold-out pag-
es!
Figure A
Tools needed for installation (not supplied)
Figure B
Attach the accessory holder to the de-
vice.
Figure C
Attach the transport handle.
Insert holder for trigger gun.
Figure D
Attach support leg.
Figure E
Attach expanding rivet to axle.
Insert expanding rivet to axle.
Figure F
First push the transport wheel, and then
the sleeve onto the axle.
Figure G
Insert the axle into the bearings.
Figure H
Always hold against axle when performing
the following steps.
First push the sleeve and then the
transport wheel onto the axle.
Attach expanding rivet to axle.
Insert expanding rivet to axle.
Figure I
Attach the wheel caps.
Figure J
Push the high pressure hose into the
trigger gun until it locks audibly.
Note: Make sure the connection nipple
is aligned correctly.
Check the secure connection by pulling
on the high-pressure hose.
17
English

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents