Maintenance; Technical Data - Hyundai VK 301 Instruction Manual

After boiling the appliance switches off automatically. Before reaching the boiling point, you can
switch off the appliance by turning the A1 button to the 0 position. Always use fresh drinking water
for boiling.
ATTENTION
– When heating water, the lid must be closed, otherwise the kettle will not turn OFF.
– In bigger tilting of the electric kettle backwards, particularly when it is filled up to maximum, water
can flow out from the electric kettle in the bottom part of the kettle.
This does not affect safety or other functions and it does not mean any failure of the electric
kettle. In the case of tilting the electric kettle with hot water there is a risk
of scalding. Therefore do not tilt the electric kettle.
– If the kettle was removed from the stand during boiling, remains in ON position.
This means that if you put it back on the stand, it will immediately continue in heating.
IV. MAINTENANCE
Unplug the appliance from power supply by taking the fork of the power cord out of the
socket! Clean the kettle only when it is cooled down! Do not use rough and aggressive
detergents (e.g. sharp objects, scrapers, diluting agents or other solvents)! The casing of the
electric kettle and the heating bottom is made of top-quality stainless steel, but in common use,
impurities from water get stuck on them (water scale), particularly above the heating element.
It is not rust or another material defect of the kettle container and the appliance is not
subject to a complaint for this reason.
Cleaning the sieve (A7)
Take the sieve from the kettle. Clean it from possible sediments in running water using a fine brush.
Then put the sieve back in the opposite way.
Cleaning the kettle
In the hard water area, it is important to do the decalcification regularly to keep the kettle in good
working condition, because too much scale inside may cause the kettle fail to work. For the best
performance of your kettle, decalcify the unit from time to time. The frequency depends on the
hardness of your tap water and how many times you have used the kettle. Decalcification will clean
the interior of the unit.
This may be done in the following manner:
Put about 50 g of citric acid into the kettle with limescale sediment. Fill the kettle half with water and
stir. After dissolving, fill it up to ¾ of maximum amount of water. Place the kettle on the stand and
turn on. Turn off the kettle before reaching boiling point, let the solution work for 10 minutes and
then pour it out. Rinse the kettle thoroughly with clean water. In case of very thick sediments, you
can repeat the process. Clean the kettle regularly!
V. TECHNICAL DATA
• Input 2200 W
• Max. capacity 1,7 liters
• Weight (kg) approximately 1
• Protection class of the appliance I.
• Size, (cm) 21,5 x 16 x 24
• Input in off mode is 0.00 W
Expert service must do the large maintenance or to intervene into inside parts of the
appliance! Non-observance of the instructions of the manufacturer cancels the right for
guarantee repair!
20 / 26