Specifications; General Power Tool Safety Warnings; Save All Warnings And Instructions For Future Reference - Makita JS1600 Instruction Manual

ENGLISH
1. Lock-off lever in the FREE
position
2. Switch lever (Paddle switch)
3. Lock-off lever in the LOCK
position
4. Lock-off lever
5. Switch lever
6. Gauge for stainless: 1.2 mm
(3/64")

SPECIFICATIONS

Max. cutting capacities
Strokes per minute (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
..... Read instruction manual.
.............. DOUBLE INSULATION
Intended use
The tool is intended for cutting sheet steel and stainless
sheet steel.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
4
Explanation of general view
7. Gauge for mild steel: 1.6 mm
(1/16")
8. Lower blade
9. Loosen
10. Upper blade
11. Upper blade securing bolt
12. Hex wrench
13. Thin washers
14. Blade holder
Model
Steel up to 400 N/mm
Steel up to 600 N/mm
Steel up to 800 N/mm
Aluminum up to 200 N/mm
Min. cutting radius
-1
)
Overall length
Net weight
Safety class
END201-5
ENE037-1
ENF002-1
15. Tighten
16. No gap allowed
17. Yoke
18. Lower blade positioning screw
19. Workholder
20. Cutting line
21. Limit mark
22. Screwdriver
23. Brush holder cap
2
2
2
2
General Power Tool Safety
Warnings
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Work area safety
1. Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
2. Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
3. Keep children and bystanders away while
operating a power tool. Distractions can cause you
to lose control.
JS1600
1.6 mm (16 ga.)
1.2 mm (18 ga.)
0.8 mm (22 ga.)
2.5 mm (13 ga.)
30 mm
4,000
230 mm
1.8 kg
/II
GEA005-3