Appendix #6 - Hardware Reset; Digiviewer Reset; Hardware Reset - Digimerge DNP5220E Hardware Manual

Table of Contents

Advertisement

SECTION 5

Appendix #6 - Hardware Reset

There are 2 ways to reset the IP Device:

DigiViewer Reset

To restore Factory Defaults from the DigiViewer Web Browser Interface (Note: This only works if
the network browser access to the device is operational):
• Log into the video device as
administrator using the admin
username and password. This
applies only if users are set up in
the device. If not then just open
the web page.
• Select the 'Settings' page in the
DigiViewer.
'Advanced Settings' link. Click on
the 'Factory Settings: Restore'.
• Close the browser. To access the
device again refresh the browser
after 30 seconds.
NOTE: This will not reset Networking and
Account Settings.

Hardware Reset

To Restore Factory Defaults from the Hardware:
• Unplug the power jack to turn off the device. Uncurl a paperclip about 2cm long, insert it
into the "Factory Default Hole" and push
the button behind the hole. Hold this and
do not release.
• Plug in the power jack to turn on the device.
Observe the Power LED - when power on
the LED is red, wait for a few seconds.
The LED will change to orange, flash four
times and then change back to red. At this
moment release the factory default button
and the device will be restored to factory
default settings.
NOTE: Allow time for the camera to restart
(approximately 1 minute).
Revision 1.0
Appendix #6 - Hardware Reset
Click
on
the
39

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DNP5220E and is the answer not in the manual?

Questions and answers

Table of Contents