Network Connectivity Overview
Network Connectivity Overview
This camera is designed to be remotely controlled using your existing network and the provided
DigiViewer software (or a 3rd party compatible application - visit us on the web for an updated
compatible software list).
1. Connect the Camera to the Router or Switch using an Ethernet Cable, and power on the Camera.
NOTE: The Camera must be connected to the router prior to connecting the power to the
IP Device.
2. Locate the MAC and IP address of your Camera using the provided DigiConsole Setup Utility.
See next page for details.
3. Run the DigiConsole Software from the provided CD (optional installation to PC), and configure
the DigiViewer to allow DDNS connectivity. Refer to page 25 for details. See the DigiConsole
/ DigiViewer Software Guide (provided with this Camera) for installation requirements and
details on using the software.
INTERNET
20
CAMERA
ROUTER
(Not Included)
HARDWARE MANUAL |
Copyright
SECTION 4
PC
(Not Included)
©
2007 Digimerge Technologies Inc.
Need help?
Do you have a question about the DNP5220E and is the answer not in the manual?