Mitsubishi Electric PCFY-P40VGM-E Technical & Service Manual page 25

OPERATING PROCEDURE
3. Removing the fan motor
(1) Remove the air intake grille.
(2) Disconnect the fan motor guard.
(3) Unscrew screws for removing the motor guard.
(4) Unscrew screws for removing the fan guard.
(5) Remove the screw for removing the motor support at
both left and right side.
(6) Loosen the set screws at the fan motor side of the
connecting joint.
(7) Slide the fan motor to the left side and pull it out.
4. Removing the sirocco fan
(1) Remove the air intake grille.
(2) Remove 1 beam.
(3) Unscrew screws for removing the motor guard.
(4) Unscrew screws for removing the fan guard.
(5) Remove the lower casing while pressing the stoppers at
upper side of the casing.
(6) Loosen the set screws at the connecting joint.
(7) Remove the sirocco fan and shaft together by sliding the
shaft to the left.
(Note)
Make sure that the upper side casing is snapped to the fan
plate securely with catch.
5. Removing the side panel
(1) Remove the air intake grille.
(2) Remove the screw from the side panel, and remove the
side panel by sliding the panel to the front.
PHOTOS & ILLUSTRATIONS
Photo 2
Screws
Motor support
Photo 3
Motor
Figure 3
25
Motor guard
Motor
Set screw
Connecting joint
Motor guard
Sirocco fan Casing
Connecting
joint
side panel
sliding the panel
to the front
screw
Fan guard
Bearing