Introduction This manual will provide assistance in integrating I-View Video Verification functionality based on sensor events configured in Lilin 6122 HD camera. It is not a replacement for Lilin camera manuals available at http://www.meritlilin.com. A picture of the Lilin 6122 HD camera is shown below: Figure 1 Once the IP camera has been set up as described in subsequent sections it’s ready to be tested with I-View.
Workflow The following steps describe a high level workflow to be followed in order to properly configure and install a Lilin 6122 IP Camera to work with I-View Now. Subsequent sections will provide more detail on each step outlined here.
Finding the Camera’s IP Address The Lilin camera by default uses DHCP to obtain an IP address from the Internet facing router/firewall it subtends from. To find the address the Lilin is currently assigned, IP scanning tools (IPScan) are available at http://www.meritlilin.com/us/support-download.asp?c4#c4 for various Operating Systems, as shown below, that will...
Recording Setup The Lilin 6122 IP camera supports various recording modes which can be enabled via the user interface for the camera. Before you can set up the camera to begin recording, you must configure general recording settings for the analog cameras.
Event Recording As mentioned, this section is closely related to alarm setup above. When the Lilin IP camera receives an alarm directive via URL it should immediately capture the pre and post alarm video associated with the alarm condition. The intent of the following menu panel is to show how to configure that to occur.
Good luck testing with the Lilin 6122 IP camera and I-View. The two components together make for a powerful video verification capability and should provide a significant improvement to the overall security strategy for your company, home or institution.