Speaker Connections - Sonance SR 2-125 Instruction Manual

S R 2 - 1 2 5 T W O - C H A N N E L A M P L I F I E R I N S T R U C T I O N M A N U A L

Speaker Connections

For the best sound you should
use premium speaker wire that
complies with fire rating codes.
Be sure to check local codes
governing wire that may
installed within walls or ceilings.
SONARRAY amplifiers are stable
with any reputable brand
speaker wire or cable. The SR
2-125 amplifiers use speaker block
connectors that can accommodate
up to 12 gauge wire (see Figure 9).
NOTE: ALWAYS CHECK LOCAL BUILDING CODES BEFORE
INSTALLING WIRE IN WALLS OR CEILINGS.
Source Connections SR 2-125
On the left side of the rear panel are the audio inputs for the left
and right channels. In addition to the left and right inputs there are
also loop outputs for each channel.
The analog loop outputs are non buffered. The maximum number of
amplifiers that can be looped together will depend on the
output capability of your source component. The digital outputs
are buffered and can support multiple amplifiers. The source
connected to the LEFT and RIGHT LINE IN Inputs pass through the
LEFT and RIGHT LINE Outputs (see Figure 10). This also applies to
the Coax and Toslink inputs.
FIGURE 10: SR 2-125 LEFT, RIGHT LINE INPUTS/OUTPUTS
be
of
FIGURE 9:
SPEAKER CONNECTORS
Volume Level Control
Volume can be controlled from the
individual recessed volume level control
screws, located on the front panel (see
Figure 11). These volume controls balance
the desired sound levels per channel.
The volume level controls are set to
maximum, fully clockwise, by default.
IMPORTANT: USE CAUTION WHEN SETTING VOLUME LEVELS
EITHER ON THE AMPLIFIER OR AN AUDIO SOURCE AS NOT TO
OVERDRIVE AND POSSIBLY DAMAGE SPEAKERS. VERIFY ALL
SOURCES AS OUTPUT VOLTAGE VARIES FROM DEVICE TO DEVICE.
7
FIGURE 11: VOLUME
LEVEL CONTROL