Introduction; Product And Function Descriptions; Setup And User Guide - Dantherm CDT 90 MKII Service Manual

Product and function descriptions

Introduction

How it works
Illustration
Drain
2

Setup and user guide

This section provides a product description of the CDT 90 MKII, plus a description of its
functionality.
Air flow through the dehumidifier:
How the air changes as it passes
through the dehumidifier:
The fan draws humid air through a fil-
ter inside the dehumidifier.

The air is cooled, causing the moisture
content to condense into drops of wa-
ter, which are passed through the
drain hose to a drain.

The air is reheated using heat from the
dehumidifier's operation (temperature
increase of approx. +5 °C).
As the air is repeatedly circulated through the dehumidifier, its moisture content is re-
peatedly reduced, resulting in rapid, gentle drying. The dehumidifier can run constantly,
or be controlled by a built-in hygrostat.
Illustration of dehumidifier:
Rear view
Condensation is collected in the integrated drip tray, and then passed via the ½" hose
connector provided to a drain.
The hose connector should be fitted immediately after unpacking.
www.dantherm-ltd.ru • info@dantherm-ltd.ru • +7 (495) 545-48-79
Москва. Каширский проезд д. 19 стр. 2
Handle
Control panel
Air intake with PPI filter be-
hind grille
Power cord
Air exhaust
Drain
Data socket
remote monitoring
Type plate behind cover
Wheel
Front view
Continued on next page