Table of Contents
Advertisement
1、 、 、 、 Overview
Introduction:
The target groups for this Service Manual are the technicians who install and maintain this unit.
The manual covers a functional description, replacement of parts as well as how to carry out
preventive maintenance.
The part No. of this service manual is 214369.
Usage of the product
This unit is especially designed for cooling of electronic equipment and for door mounting. The
unit requires access to ambient air through slots on the backside of the unit. The unit must under
no conditions be used for other purposes and should be installed and placed according to the in-
structions in this manual.
Storage
If the unit is stored in a warehouse the following conditions apply:
1
T emperature range between – 40
、
2
O perating and storage range: 5~95% RH.
、
3
、
T he unit must be stored in an upright position.
Identification of the Unit
All units have a silver type plate label, where all the important information about the specific unit
can be found. Also the Dantherm address and phone numbers are printed here so the contact
can be made on the site.
Serial Number: Especially the serial number is important, and should always be mentioned when
Dantherm is contacted about issues concerning the specific unit.
Copyright© © © ©
This manual is subject to changes without notice. The manual or parts of it cannot be copied
without a written permission of the Dantherm Group.
to + 85
.
℃
℃
5 of 53
Advertisement
Table of Contents
