Display Assembly; Removing The Display Assembly - Dell Inspiron 1320 Service Manual

Back to Contents Page
Display
Dell™ Inspiron™ 1320 Service Manual
Display Assembly
Hinge Caps
Display Bezel
Display Panel
Display Panel Bracket
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see
computer.
Display Assembly

Removing the Display Assembly

1. Follow the instructions in Before You
2. Remove the battery (see Removing the
3. Remove the module cover (see
4. Disconnect the antenna cables from the Mini-Card.
5. Remove the center control cover (see
6. Remove the keyboard (see
7. Remove the hard drive (see
8. Remove the palm rest (see
9. Disconnect the display cable and the camera cable from their respective system board connectors.
10. Remove the six screws (three on each side) that secure the display assembly to the computer base.
Begin.
Battery).
Removing the Module Cover).
Removing the Center Control
Removing the Keyboard).
Removing the Hard Drive).
Removing the Palm Rest).
Removing the
Cover).
Battery) before working inside the