Moving And Installing; Removing The Transit Bolts; Moving The Washing Machine From One Location To Another - Logik L714WM15E Installation Instructions Manual

INSTALLATION

Moving and Installing

Removing the Transit Bolts

Four transit bolts keep the interior of the washing machine in place while it's being moved.
They need to be removed before installation. Use a spanner (not supplied) and follow the
instructions detailed below.
Don't run the washing machine without removing the transit bolts, as this can
cause excessive vibrations and may damage your machine.
To remove the transit bolts:
1. Use a spanner to loosen the four bolts. They are located at the rear of the washing
machine.
2. Pull the bolts out horizontally. Make sure the entire bolt is removed.
3. Push the four cover caps (included with your accessories) into the respective bolt holes.
You'll need the transit bolts again if you move the washing machine, so make sure
you keep them in a safe place.

Moving the Washing Machine from One Location to Another

Before you move the washing machine:
• Shut off the tap and run the washing machine to drain the water. Drain any remaining
water from the pump hose.
• Disconnect the mains cable.
• Attach the transit bolts.
Make sure to fix the transit bolts prior to moving the washing machine.
GB
23