Operation - Yardworks 60-3815-0 Owner's Manual

GENERAL CULTIVATING
See Figure 10.
Shallow cultivating (less than 2" (5 cm) deep) can be used
to disrupt weeds and aerate the soil without injuring nearby
plant roots. It should be done often so that weeds do not
grow large and get tangled in the tines of the tiller.
The two outer tine blades can be removed from the unit in
order to allow for a more narrow cultivating width. Follow
these steps to remove the two outer tines:
Disconnect the battery from the tiller; remove the hitch pins
from the holes on the ends of the tine shaft; remove the
outside tine blades and felt washers from the tine shaft;
and insert the hitch pins into the holes that were uncovered
when the felt washers were removed.
NOTE: The tiller will not operate properly if the tines are
not installed correctly. If there is a problem with the
cultivating operation of the tiller, check the tines for proper
positioning.

OPERATION

EDGING FEATURE
See Figure 11.
This tiller is equipped with an edging feature.
Remove the tines.

Install the edging wheels and the edging blade.

(See Figure 9.1-9.2)
Fig. 10
17
Fig. 11