Yardworks 60-3815-0 Owner's Manual page 11

INSTALLING THE TINES
See Figure 6.1-6.4
The tiller comes with four tines. In order for the tiller to work properly, the tines must be installed in the correct order.
The tiller can be used with four tines or two tines.
Disconnect the battery from the tiller.

Lean the unit back on its wheels so that the handlebar rests on the ground.

Fig. 6.1
2
FLUTE
1. Place tine (2) onto the shaft. The flute of tine (2)
should face away from the gear box. (Fig. 6.1)
Fig. 6.2
1
2. Place tine (1) onto the shaft. The flute of tine (1)
should face in toward tine (2). Insert the hitch pin into the
holes in order to secure the tines to the tine shaft. (Fig. 6.2)
NOTE: When they are installed correctly, the flute on the tines should line-up, and the angled edge of the tine blades
should point toward the ground (Fig. 7).
NOTE: The tiller will not operate properly if the tines are not installed correctly. If there is a problem with the cultivating
operation of the tiller, check the tines for proper positioning.
Note: The directional arrow that is displayed on each tine should point toward the front.
ASSEMBLY
FRONT
2
GEAR BOX
TINE SHAFT
FRONT
2
Fig. 6.3
FRONT
1
2
GEAR BOX
3. Place tine (3) onto the shaft. The flute of tine (3)
should face away from the gear box. (Fig. 6.3)
Fig. 6.4
FRONT
1
2
3
4. Place tine (4) onto the shaft. The flute of tine (4)
should face in toward tine (3). Insert the hitch pin into the
holes in order to secure the tines to the tine shaft. (Fig. 6.4)
11
3
FLUTE
4