TP-Link TL-WR1043ND User Manual page 35

 Connect Automatically - The connection can be re-established automatically when it was
down.
 Time-based Connecting - The connection will only be established in the period from the
start time to the end time (both are in HH:MM format).

Note:
Only when you have configured the system time on System Tools -> Time page, will the
Time-based Connecting function can take effect.
Connect Manually - You can click the Connect/ Disconnect button to connect/disconnect

immediately. This mode also supports the Max Idle Time function as Connect on Demand
mode. The Internet connection can be disconnected automatically after a specified inactivity
period and re-established when you attempt to access the Internet again.
Caution: Sometimes the connection cannot be terminated although you specify a time to Max Idle
Time, since some applications are visiting the Internet continually in the background.
If you want to do some advanced configurations, please click the Advanced button, and the page
shown in Figure 4-11 will then appear:
MTU Size - The default MTU size is "1480" bytes, which is usually fine. It is not

recommended that you change the default MTU Size unless required by your ISP.
Service Name/AC Name - The service name and AC (Access Concentrator) name, which

should not be configured unless you are sure it is necessary for your ISP. In most cases,
leaving these fields blank will work.
TL-WR1043ND
Figure 4-11 PPPoE Advanced Settings
-26-
450Mbps Wireless N Gigabit Router