Network; Wan - TP-Link TL-WR1043ND User Manual

III. Enter the router's PIN on your client device
Use this method if your client device asks for the router's PIN number.
Step 1: On the client device, enter the PIN number listed on the router's Wi-Fi Protected Setup
screen, shown in
Step 2: The Wi-Fi Protected Setup LED flashes for two minutes during the Wi-Fi Protected
Setup process.
Step 3: When the WPS LED is on, the client device has successfully connected to the router.

Note:
1) The WPS LED on the router will light green for five minutes if the device has been
successfully added to the network.
2) The WPS function cannot be configured if the Wireless Function of the router is disabled.
Please make sure the Wireless Function is enabled before configuring the WPS.
4.5

Network

Figure 4-7 the Network menu
There are three submenus under the Network menu (shown in
LAN. Click any of them, and you will be able to configure the corresponding function.
4.5.1

WAN

Choose menu "Network→WAN", and then you can configure the IP parameters of the WAN on
the screen below.
1. If your ISP provides the DHCP service, please choose Dynamic IP type, and the router will
automatically get IP parameters from your ISP. You can see the page as follows (Figure 4-8):
TL-WR1043ND
(It is also labeled on the bottom of the router).
Figure 4-3
-22-
450Mbps Wireless N Gigabit Router
Figure 4-7 ): WAN, MAC Clone and