Eko Warrior ks50-dc Installation And Operating Instructions Manual page 40

Display of current operating mode
During normal operation, the following information will be displayed on the control panel:
Heating Mode
Compressor
Speed
OPER. WARMWATER
95%
1
Symbols
So that you may see at a glance the operating mode, the following symbols will be appear in the lower part
of the display depending on which part of the unit is working:
Compressor Add Heat ON Room Heat
Outdoor Unit
Running
CSP reading on display
the bottom right position of the display and will automatically disappear when the compressor restarts.
If the symbol is empty, the hot water temperature is below the setting temperature. It does not refer to the
amount of water in the tank which should, of course, normally be full.
If the symbol is full, it means the hot water temperature has reached or exceeded the temperature set in
the TEMPERATURE submenu.
that sterilisation is taking place
39
Room Temperature
Sensor
HDO
CSP
1
Hot Water
Demand
.
Locked Display
Timer ON
If timers are required set for both heating
and hot water even if hot water is from
00.00 to 23.59
HDO
CSP
Cylinder Temperature