Warming Up The Engine - TOHATSU MFS 20d Owner's Manual

38
ENGINE OPERATION
ENOW00860-0
Be sure to keep the harness away from the
rotation parts.
6. Be sure to install the stop switch lock
to the stop switch, and attach the stop
7
switch lanyard securely to the operator
or to the operator's PFD (Personal Flo-
tation Device.)
7. Set the control lever in the Neutral
position.
8. Pull the starter handle slowly until you
feel engagement, keep pulling till you
feel less resistance. Then pull it quickly.
9. After engine starts, do not reinstall fly-
wheel cover and top cowl.
ENOM00518-0
If the choke solenoid fails to
operate (EP and EPT type only)
1. Remove the top cowl.
2. Close the choke plate by finger.
3. Raise the Free accel lever a little.
4. Turn the main switch key to start posi-
tion.
ENOF01214-0
CAUTION
5. Stop pushing the key when the engine
has started.
6. Return the choke plate to open posi-
tion.
ENOM00043-B

3. Warming up the engine

ENOW00932-0
CAUTION
Be sure to check that cooling water is
coming out of the cooling water check port
during warm up.
Warm the engine at low engine speeds for
about
ENOF00320-0
ENOF00321-0