Table of Contents
Advertisement
Symptom
Drop-in Charger LED
light does not come on
Low battery indicator is
blinking although new
batteries are installed
Cannot activate VOX
Battery doesn't charge
although it has been
placed in the drop-in
charger for a while
Note:
XTNi™ radios can also be programmed using the CPS. This special software can set up features or restrict values in the radio.
Whenever a feature in the radio seems to not correspond to the default or preprogrammed values, check to see if the radio has
been programmed using the CPS with a customized profile
English
50
Check radio/battery is properly inserted and check battery/charger
contacts to be sure they are clean and charging pin is inserted correctly.
Refer to 'Charging the Battery' section on page 17, 'Drop-in Tray Charger
LED Indicators' section on page 21 and 'Installing the Lithium-Ion Battery'
section on page 13.
Verify that the radio is set to the correct battery type. Refer to the 'Installing
the Li-Ion Battery' section on page 13, '"Installing Alkaline Battery Pack" on
page 14' on page 14 and 'About your Li-Ion Battery' section on page 11.
VOX feature might not have been set to ON. Using CPS, make sure the
VOX Sensitivity level is not set to 0. Accessory not working or not
compatible. Refer to 'Hands-Free Use/VOX' section on page 28.
Check drop-in charger is connected and correspond to a compatible power
supply. Check you have the drop-in charger adjustable piece, placed on
the right position (refer to 'Charging with the Drop-In Tray Single Unit
Charger' and 'Charging a Stand-Alone Battery' section on page 18). Check
the charger LEDs indicators to see if battery has a problem. Refer to
'Drop-in Tray Charger LED Indicators' section on page 21.
.
Try This
Advertisement
Table of Contents
