Motorola XTNI Non-display Model User Manual page 41

• Short press the PTT button to enter
Frequency Mode. Radio will signal current
value '0' (orange blink)
• Press the SB1 button once to increase first
digit to '1'.
• Short press the PTT button once to move
ahead and program the frequency's second
digit. Radio will signal current value which is '2'
(two red blinks).
• Press the SB1 button to increase the digit
value to '3'.
• Long press the PTT button. LED indicator will
show a green heartbeat to indicate 'Idle' state.
• Long press the PTT button to exit
Programming Mode or turn radio OFF.
Example of Programming a Code
Assuming current code value is set to factory
default '001', and you want to change it to
CTCSS/DPL Code = 103 follow the sequence
below:
• Enter Programming Mode
• Short press the PTT button three times (Enter
CTCSS/DPL Programming Selection Mode).
Radio LED will blink orange to indicate that
current value is '0' • Press the SB1 button once
(to change first digit to '1') LED indicator will
blink red. Short press the PTT button (to move
forward and program second digit). Radio LED
will blink orange to indicate current value is '0'.
• Short press the PTT button and move ahead
to program the third digit. LED indicator will
blink red to indicate current value is '1'.
• Press the SB1 button to change the 'third
digit' to '2'. Press the SB1 button to change
again this 'third digit' to '3'. Radio will signal the
chosen value.
• Long press the PTT button to save changes
and return to 'Idle' Programming Mode.
• Once in 'Idle' Programming Mode, LED
indicator will start blinking a green heartbeat.
• Long press the PTT button to exit
Programming Mode.
39
English