When Ordering The Muc - Motorola XTNI Non-display Model User Manual

Press and release SB1.
4. After cloning is completed, the Source radio will
sound either a 'pass' tone (cloning was successful)
or a 'fail' tone (cloning process has failed). The
'pass' tone sounds like a good key 'chirp' whereas
the 'fail' tone sounds similar to a 'bonk' tone. If the
Source radio is a display model, it will either show
'Pass' or 'Fail' on the display (a tone will be heard
within 5 seconds).
5. Once you have completed the cloning process,
turn the radios OFF and ON to exit the 'cloning'
mode.
If cloning fails please refer to "What to do if
cloning fails" on page 47.
Further details on how to clone units are
explained in the instructions sheet provided
with the MUC.

When ordering the MUC

See "Chargers" on page 59 for the MUC part
number.
Note: (*) MUC pockets numbers should be
readfrom left to right with the Motorola logo
facing front.
Paired Target radios and
Source Readios must be
! !
of the same type in order
for the cloning to run
successfully.
W A R N I N G
Cloning Radio using the Radio to Radio
(R2R) Cloning Cable (optional accessory)
45
English