SC-S80600 Series/SC-S60600 Series/SC-S40600 Series User's Guide
Attaching the Roll Core
Preparing
Use a roll core that is longer than the width of the
media.
This allows the media to be taken up without
protruding from the core.
Prepare the supplied paper tape.
We recommend this method for attaching media to
the roll core due to the following advantages.
❏ It allows you to prevent misalignment of the roll
at the left and the right edges, and to prevent the
media from moving around, which provides a
stable printing length for print jobs.
❏ Media is not wasted.
❏ Media can be easily removed from the roll core
after winding.
When the supplied paper tape runs out, purchase
commercially available paper tape with a width of 20
to 25 mm (that is not easily stretched or cut). If you do
not have any paper tape, cut media into pieces that are
20 to 25 mm wide and approximately 70 cm long.
Basic Operations
Loading
A
Keep the d button pressed until the leading
edge of the media reaches the center of the after
heater.
c
Important:
Always press the d button to feed the media.
If the media is pulled by hand, the media
may twist during take-up.
B
33