Epson SC-S60600 Series User Manual page 84

SC-S80600 Series/SC-S60600 Series/SC-S40600 Series User's Guide
C
Use the u button to select Grease Carriage
Rod, and then press the Z button.
When Grease kit is needed. Continue? is
displayed. Make sure that you have a grease kit
ready to use.
D
Use the u button to select Yes, and then press
the Z button.
E
Insert the tab of the pad A (new) firmly into the
rectangular slot on the grease tool and fit the
pad to the tool as shown.
F
Open the front cover.
G
Hold the pad of the tool firmly against the back
of the carriage rod A, and then slide it smoothly
from the right end to the left end to wipe off
stains on the rod.
Repeat this action four times.
Maintenance
c
Important:
Do not slide the tool back and forth.
If you slide the tool back and forth, dust will
be moved to the print head stand-by position
and a malfunction may occur.
H
Remove the dirty pad from the tool.
I
Attach a new pad A to the grease tool.
J
Using a new cleaning stick, stir the grease in the
container about ten times.
K
Wipe the tip of the cleaning stick on the edge of
the container to remove excess grease.
c
Important:
Failure to remove the excess could result in
falling grease dirtying the platen and media.
L
Using a cleaning stick, apply grease to the pad
you attached to the tool as described below.
(1) Insert the tip of the cleaning stick fully into
the container, and twist it 2 to 3 times to get
enough grease on the stick.
(2) Apply grease to the pad on the tool.
84