Piranha YQ-3888 User Manual page 9

• Place the funnel spout into the water tank opening.
• Fill the measuring cup up to the marks on the side (175ml) with clean water and pour the
water into the tank.
Note: Do not overfill the tank as some air space must be left in the tank for correct
operation.
• Remove the funnel and re-fit the safety screw cap.
Note: Screw the cap in clockwise as far as possible then push down hard on the cap top
and turn to fully tighten the cap in position.
Constant downward pressure is required when screwing the Cap Closed
• Check the power supply and socket, and confirm they comply with the requirements given
in the Instruction Manual.
• Turn on the power supply.
• Allow at least 3 minutes after the power supply is turned on for the appliance to heat up.
The orange indicator light will go out when operating temperature has been reached.
• Lightly press the steam button and check whether steam jets out of the nozzle. (DO NOT
aim the spray nozzle at other persons or objects).
• If the steam jets out, the setup is complete.
• Release the button and install the required accessories according to your needs. NOTE:
Refer to the Function section for selection of accessory and correct method of attaching
the accessories..
NOTE: It is highly recommended to disconnect the plug from wall socket, let cool and
release all internal pressure before changing the attachments as the nozzle will be
extremely hot.
Press the steam button to release the pressure. Never open the cap to release pressure as
Injury may result.
• When the desired accessory has been fitted and the unit has reached operating
temperature, press the steam button in order to carry out the operations required by you.
Note: The Indicator Light will turn On and Off during use. This indicates that the temperature is
being maintained.
Page 9 of 14