Figure 5: Console Connection In Terminal Window - Pakedge SW24-GBM Quick Installation Manual

TO RESET THE IP ADDRESS OF THE SWITCH USING THE SUPPLIED CONSOLE CABLE (continued)
Once the connection is established through the console cable, you will be able to configure the switch
through the Terminal Program. To configure your switch back to the default network IP address of
192.168.1.201 with a subnet of 255.255.255.0, continue with the following steps:
4. Once the terminal screen pops up you will see a screen similar to the one in Figure 5. Once this
screen appears, hit enter (there is no password).
5. Type: IP Setup 192.168.1.201 255.255.255.0 192.168.1.99<ENTER>
6. Your switch should now be
accessible from the network.
Figure 5:
Console Connection in
Terminal Window
SW24-GBM QUICK INSTALLATION GUIDE
10