Table of Contents
Advertisement
EN
20
Troubleshooting guide
No water coming
out of nozzle
Spray Gun Trigger
will NOT Move
Unit will NOT start
Note: Unit
will only start and
run when trigger
is depressed and
water is spraying!
Motor stops working
during normal
operation
Note: Motors
thermal overload
switch tripping
the motor is
overheated
Allow the motor
to cool for 20
minutes before
troubleshooting
and the switch will
automatically reset
Nozzle is clogged
Water inlet filter
screen is clogged
Kink in the garden
hose or hose is
wrapped on a storage
wheel
Gun safety lock is
engaged
Unit is not turned ON
Extension cord is too
long or wire- gauge is
too small
Defective Spray Gun
Clean the nozzle according to the instructions
provided in the Nozzle paragraph under
Maintenance section of this manual.
Remove filter screen (O) from the water inlet
(M) and clean it thoroughly. Replace the filter
screen.
Use a maximum garden hose length of 50
ft. {15,2 m (city water) or 25 ft. (7.6 m) (well
water). Ensure the garden hose is laid flat and
does not have any kinks or leaks. Unwrap
garden hose from reel or hook (if applicable).
Replace garden hose if necessary.
Release safety lock according to instructions
provided in the Starting paragraph under
Operation in this manual.
Verify that the ON/OFF switch is full ingaged in
the ON position.
We do not recommend using of extension
cords with your high-pressure washer. If you
must use an extension cord, verify that it
meets the minimum requirements listed in the
Extension Cord paragraph under the Power
Supply & Electrical info in this manual.
Clean the nozzle according to the instructions
provided in the Nozzle paragraph under
Maintenance section of this manual.
FDW 2002 E
Advertisement
Table of Contents
