Table of Contents
Advertisement
Check List
Ship Name
SCANNING
TYPE
SONAR
S/N
Monitor unit (FSV-2400)
Control unit (FSV-2401)
Processor unit (FSV-2402)
Transceiver unit (FSV-241E)
Power supply unit (FSV-242)
Hull unit (FSV-243E/244E )
Reference
Frequency
24KHz
Transducer location
Note:
NO
CHECK ITEMS
1
Unit installation
2
Grounding
3
Connection
4
Power Supply
(Ship's mains)
5
Output power
6
Test
7
Setting
8
Operation check Check pictures after turning on the power.
Date
/
FSV-24
CONTENT
All units are installed according to installation
manual.
Copper plate should be connected for the
following units.
1.Power supply unit
2.Transceiver unit
3.Junction box(Option)
IV-8sq is connected for the following units.
1.Raise/lower box
2.Processor unit
3.Monitor unit
Check the connection between each unit.
1.Transducer-Transceiver unit
2.Transceiver unit-Processor unit
3.Processor unit-Monitor unit
4.Monitor unit-Control unit
5.Processor unit- Other equipments
6.Ship's mains-Power supply unit
7.Ship's mains-Hull unit
8.Ship's mains-Processor unit
Check ship's mains voltage for following units.
1.Power supply unit
2.Raise/lower motor line
Check whether led of phase detector is light or
not.
The 3 phase line must be changed if led is light.
3.Processor unit
Check output power and +B voltage.
Check the following tests.
Board test/Panel test/RX test/Channel
test1/Channel test2/Noise test
Check the user program setting.
AP-1
/
Location
Options
CS-120A
VI-1100A
CS-170
FSV-2451(5m),FSV2452(15m)
Good/No Good
Good/No Good Sheet 1
Good/No Good Sheet 1
Good/No Good Sheet 1
Good/No Good Fig1
Good/No Good Sheet2
Good/No Good
RESULT
RESULT
DATA
Installation
manual
Sheet3
Advertisement
Table of Contents
