Table of Contents
Advertisement
3. ADJUSTMENTS AND CHECKS
Note: If transducer registration is aborted for any reason, the following message ap-
pears. Select [Quit] to close the message and restart the procedure once safety is en-
sured.
3.8
How to Check the Hull Unit
Do not transmit while doing this procedure.
How to enable transmission
The default transmission state is OFF. Enable transmission as shown in the procedure
below. NEVER transmit when the vessel is in dry dock, to prevent damage to the
transducer.
1. Turn on the power and press the MENU/ESC key to open the menu.
2. Use the trackball to select [Others] then right-click.
3. Select [Initial Setting] then left-click.
3-6
Registering Transducer Positions
Ensure safety before registering transducer positions.
Quit
Advertisement
Table of Contents
